Chapter 11 Description of Parameter Settings|C200 Series
11-129
Settings 0.00~600.00Hz
When Pr.00-20 is set to 1 (RS485 communication). The AC motor drive will save the last
frequency command into Pr.09-10 when abnormal turn-off or momentary power loss. After reboots
the power, it will regards the frequency set in Pr.09-10 if no new frequency command is inputted.
Block Transfer 1
Block Transfer 2
Block Transfer 3
Block Transfer 4
Block Transfer 5
Block Transfer 6
Block Transfer 7
Block Transfer 8
Block Transfer 9
Block Transfer 10
Block Transfer 11
Block Transfer 12
Block Transfer 13
Block Transfer 14
Block Transfer 15
Block Transfer 16
Factory Setting: 0.00
Settings 0.00~655.35
There is a group of block transfer parameter available in the AC motor drive (Pr.09-11 to Pr.09-20).
User can use them (Pr.09-11 to Pr.09-20) to save those parameters that you want to read.
~
Reserved
Communication Decoding Method
Factory Setting: 0
Settings 0: Decoding Method 1
1: Decoding Method 2
Decoding Method 1 Decoding Method 2
Digital Keypd Digital keypad controls the drive action regardless decoding method 1 or 2.
External Terminal External terminal controls the drive action regardless decoding method 1 or 2.
RS-485 Refer to address: 2000h~20FFh Refer to address: 6000h ~ 60FFh
CANopen Refer to index: 2020-01h~2020-FFh Refer to index:2060-01h ~ 2060-FFh
Source of
Operation
Control
Communication
Card
Refer to address: 2000h ~ 20FFh Refer to address: 6000h ~ 60FFh
Call 1(800)985-6929 for Sales
Call 1(800)985-6929 for Sales
To Next Page
Loading...
