Delta C200 Series - Page 235

Chapter 11 Description of Parameter Settings|C200 Series
11-136

PM Sensorless Obeserver Bandwith for High Speed Zone
Factory Setting: 4.00
Settings 0.00~600.00Hz

PM Sensorless Obeserver Bandwith for Low Speed Zone
Factory Setting: 0.50
Settings 0.00~600.00Hz

PM Sensorless Observer Low-pass Filter Gain
Factory Setting: 1.00
Settings 0.00~655.35Hz

Speed bandwidth switching
Factory Setting: 10.00
Settings 0.00~655.35Hz

High/Low speed OBS bandwidth
Factory Setting: 0.50
Settings 0.00~600.00Hz

PM Sensorless Control Word
Factory Setting: 0000
Settings 0000~FFFFh

Required Time for PM Sensorless d-axis Current Command Return to 0
Factory Setting: 1.0
Settings 0.0~655.35 sec

Frequency Point when switch from I/F mode to PM Sensorless mode
Factory Setting: 20.00
Settings 0.00~600.00Hz

Frequency Point when switch from PM Sensorless Observation mde to I/F mode
Factory Setting: 20.00
Settings 0.00~600.00Hz

I/F mode, low pass-filter time
Factory Setting: 0.2
Settings 0.0~6.0 sec

Initial Angle Detection Time
Factory Setting: 0
Settings 0~10ms
 PM Sensorless Adjustment Procedure
Call 1(800)985-6929 for Sales
deltaacdrives.com
sales@deltaacdrives.com
Call 1(800)985-6929 for Sales
deltaacdrives.com
sales@deltaacdrives.com