Delta DOP-B - Installation Procedures; Installation Notes; Installation Method

English-3
 Store within a relative humidity range of 10% to 90% and non-condensing.
 Do not store the HMI in a place subjected to corrosive gases and liquids.
 Correctly packaged and placed on a solid and durable surface.
 Do not mount the HMI adjacent to heat-radiating elements or in direct sunlight.
 Do not mount the HMI in a location subjected to corrosive gases, liquids, or airborne dust or
metallic particles.
 Do not mount the HMI in a location where temperatures and humidity will exceed
specification.
 Do not mount the HMI in a location where vibration and shock will exceed specification.
 Do not mount the HMI in a location where it will be subjected to high levels of
electromagnetic radiation.
Installation
Installation Notes
 Improper installation will result in malfunction and greatly reduce the life of the HMI. Be sure
to follow the guidelines in this quick start when installing the HMI.
 In order to ensure the HMI being well ventilated, make sure that the ventilation holes are not
obstructed and must provide sufficient free space around HMI.
 To ensure the panel is well protected, be sure to install a waterproof gasket into HMI.
 For use on a flat surface of a Type 4X "Indoor Use Only" enclosure or equivalent.
 The allowable thickness of the panel for mounting should be less than 5 mm.
Installation Method:
Step 1:
Ensure to put waterproof gasket into HMI and
then insert the HMI into the panel cutout.
Step 2:
Ensure to insert fasteners into the HMI’s
insertion slots and turn the screw till screws
touch panel cutout.
Step 3:
Turn the screw with less than torque 0.7N.M to
avoid damage to plastic box.
Torque: 6.17lb-inch (0.7N-M)
Step 4:
Keep at least 60mm distance from rear of HMI
product to the wall, installation surface or the
other controllers for heat dissipation.
Units: mm