Delta DVP-ES2 User Manual

DVP-ES2/EX2/EC5/SS2/SA2/SX2/SE&TP Operation Manual - Programming
6-6
Error code
Description
Solution
0E18
BCD conversion error
Check the D1137
(Error step number)
Re-enter the
instruction correctly
0E19 Division error (divisor=0)
0E1A Device use is out of range (including index registers E, F)
0E1B
Negative number after radical expression
0E1C FROM/TO communication error
0F04 Operand word device D register exceeds limit
0F05 DCNT operand DXXX misuse
0F06 SFTR operand misuse
0F07 SFTL operand misuse
0F08 REF operand misuse
0F09 Improper use of operands of WSFR, WSFL instructions
0F0A Times of using TTMR, STMR instruction exceed the range
0F0B Times of using SORT instruction exceed the range
0F0C Times of using TKY instruction exceed the range
0F0D Times of using HKY instruction exceed the range
1000
ZRST operand misuse
10EF E and F misuse operand or exceed the usage range
2000 Usage exceed limit (MTR, ARWS, TTMR, PR, HOUR)
Error code
Description
Solution
C400
An unrecognized instruction code is being used
A circuit error occurs
if a combination of
instructions is
incorrectly specified.
Select programming
mode and correct
the identified error.
C401
Loop Error
C402 LD / LDI continuously use more than 9 times
C403
MPS continuously use more than 9 times
C404
FOR-NEXT exceed 6 levels
C405
STL / RET used between FOR and NEXT
SRET / IRET used between FOR and NEXT
MC / MCR used between FOR and NEXT
END / FEND used between FOR and NEXT
C407 STL continuously use more than 9 times
C408 Use MC / MCR in STL, Use I / P in STL
C409 Use STL/RET in subroutine or interrupt program
C40A
Use MC/MCR in subroutine
Use MC/MCR in interrupt program
C40B MC / MCR does not begin from N0 or discontinuously
C40C MC / MCR corresponding value N is different

Delta DVP-ES2 Specifications

General

Brand	Delta
Model	DVP-ES2
Category	Controller
Language	English