Need help?Do you have a question about the Delta DVP-MC Series and is the answer not in the manual?
General| Brand | Delta |
|---|---|
| Model | DVP-MC Series |
| Category | Controller |
| Language | English |
Identifies the specific model of the Delta DVP-MC series motion controller.
Details the POWER, RUN, ERR, COM1, COM2, CAN, and MTL status indicator lights.
Describes the RUN/STOP switch, RESET button, and various communication/expansion ports.
Explains the DIN rail clip, extension module clip, and direct mounting holes.
Covers voltage, fuse, insulation, consumption, and immunity for the device's power supply.
Details I/O channels, types, terminals, delay times, input current, and cable length.
Provides pin definitions and signal assignments for COM ports (RS-232 and RS-485).
Details the RJ45 connectors for CANopen communication, including termination requirements.
Explains the 9-PIN D-SUB encoder interface for incremental or 24V/5V encoders.
Describes the Ethernet port for Modbus/TCP protocol, including pin definitions.
Recommends installing the device in an enclosure with sufficient space for heat dissipation.
Illustrates simplified models and wiring loops for sink and source input configurations.
Advises on connecting suppression circuits for big-power or frequent On/Off output applications.
Shows how to connect the DVP10MC11T to DVP-S series extension modules.
Explains ERR LED states (Off, Red flashing, quick flashing) and their troubleshooting steps.
Details CAN LED states (Green single flashing, flashing, constant, Red flashing, constant) and remedies.
Covers MTL LED states (Off, Green on, flashing, Red constant, flashing) and troubleshooting.
To Next Page
