C.
D.
A.
B.
Slide O-ring (1) over cartridge and the
bonnet nut (2). The O-ring, which acts as
a spacer to steady the sleeve, should rest
behind the bonnet nut.
Slide the sleeve (1) over the cartridge, body
and O-ring. Ensure sleeve is properly posi-
tioned over the front of cartridge.
Secure the escutcheon (1) and backplate (2)
(if your model has one) to the bracket (3) with
the 2 screws provided (4). Do not overtighten
escutcheon screws.
Install volume control handle (1) with lever to
the right. DO NOT SECURE WITH SCREW.
18 Series Installation - Separate Units
3
Valve Trim Installation
1
2
1
1
2
3
4
1
7
To Next Page
Loading...
