EasyManuals Logo

Delta Paxos User Manual

Delta Paxos
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
12
1
2
9
3
7a
G1
1/4"1/4"
6b
For Acrylic Enclosure Only
Push in the center of the acrylic anchors (G1) and squeeze
clips together. Insert acrylic anchors (G1) into hole.
If needed, a rubber mallet can be used to insert acrylic
anchors (G1).
If needed, use drill to slightly enlarge the opening of the hole.
NOTE: Acrylic anchors (G1) MUST be used.
Repeat steps 6a-7a at opposite end of enclosure.
Solo para recintos acrílicos
Empuje el centro de los anclajes acrílicos (G1) y apriete las
abrazaderas juntas. Inserte los anclajes acrílicos (G1) en el
orificio.
De ser necesario, puede utilizar un martillo de goma para
insertar los anclajes acrílicos (G1).
De ser necesario, utilice la broca para ampliar un poco la
abertura del orificio.
NOTA: DEBE utilizar los anclajes acrílicos.
Repita los pasos 6a-7a en el extremo opuesto del recinto.
For Tile Enclosure Only
After removing dam strip support (L1) and dam strip
(C1), drill a 1/4” hole at the location marked in the previ-
ous step using a tile bit.
Solo para recintos de baldosas
Después de retirar el apoyo de la barrera (L1) y la
barrera (C1), perfore un orificio de 1/4” en la ubicación
marcada en el paso anterior usando una broca para
baldosas.
CAUTION
PRECAUCIÓN
CAUTION
PRECAUCIÓN
CAUTION
To avoid risk of injury or product damage, make sure that
you drill into studs.
PRECAUCIÓN
Para evitar el riesgo de lesiones o daños al producto,
asegúrese de perforar en los montantes.
Use cut-resistant gloves with appropriate grip to avoid
risk of injury from sharp edges or corners.
Use guantes resistentes a los cortes con el agarre
apropiado para evitar el riesgo de lesiones por los bordes
y esquinas afiladas.
To avoid risk of injury or product damage, DO NOT remove
corner protectors on the glass panel(s) until the panels are
installed.
Para evitar el riesgo de lesiones o danos al producto NO quite
los protectores de las esquinas en el panel o paneles de vidrio
hasta que estos esten instalados.
CAUTION
Wear safety glasses and cut-resistant, non-slip gloves
when drilling or cutting to avoid risk of injury.
PRECAUCIÓN
Para evitar riesgos de lesiones al taladrar o cortar, use
gafas de seguridad y guantes antirresbalantes y resistentes
al corte.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Delta Paxos and is the answer not in the manual?

Delta Paxos Specifications

General IconGeneral
BrandDelta
ModelPaxos
CategoryBathroom Fixtures
LanguageEnglish

Related product manuals