Chapter 6 Control Terminals|C200 Series
6-1
Chapter 6 Control Terminals
Please remove the top cover before wiring the multi-function input and output terminals,
The drive appearances shown in the figures are for reference only, a real drive may look different.
Remove the cover for wiring.
Frame A0&A
Loosen the screws and press the tabs on both sides to remove the cover.
Screw torque:
Frame A0 : 6~8Kg-cm [5.21~6.94lb-in.]
Frame A : 10~12Kg-cm [8.68~10.4lb-in.]
Frame A0 Remove the Conduit-Box
1. Remove the cover, and then loosen the screws
of wiring guard. Keep those screws for future
use.
NOTE: C200-21 /-21M doesn’t have a plastic
circuit board.
2. Use spare screws to fasten the Conduit box.
Screw torque: 8-10Kg-cm(6.9-8.7lb-in.)
Call 1(800)985-6929 for Sales
Call 1(800)985-6929 for Sales
To Next Page
Loading...
