20
21495344.indd/311007
The radio receiver parameter programming menu is used by specially trained
personnel for programming parameters of the radio control system. The following
information of the radio control system can be displayed and four of the settings
can be changed using this menu:
Code Information
001 Transmission speed (Baud rate) of the radio receiver on the CAN
bus
002 Node-ID of the radio receiver
003 Switching on and off the CAN heartbeat function
004 Entry of the crane identification
005 Display of the serial number of the radio receiver
006 Display of the software version of the radio receiver
007 Display of the hardware version of the radio receiver
Note:
Parameters 001 to 003 only refer to radio receivers with CAN interface and are
only effective for these. Parameters 001 to 003 are set in the factory and must not
be changed without prior agreement.
Attention: Changes to the parameters of the radio receiver may impair functioning
of the hoist unit.
DRC-10:
• Actuate and hold down the Stop key
• Actuate the Lower key
• Actuate the Right key twice
• Actuate the Lower key again and hold it down for approx. 5 seconds
• Release the Lower key again
• Release the Stop key
DRC-J:
• Lock the Stop key
• Actuate display key ↓
• Actuate display key ↓twice
• Actuate display key ↓ again and hold it down for approx. 5 seconds
• Release display key ↓ again
Every change to the „Radio control parameter programming“ menu is signalled to
the crane control system.
1 Menu for programming parameters of the radio receiver
1.1 Activating the menu
To Next Page
Loading...