Den-Sin C-250E - Unpacking; Machine Installation and Setup

1. Getting acquainted with your High Pressure Cleaner
C-250E R14 Page 4
Unpacking
Remove the High Pressure Cleaner and its accessories from the packing material. For
transport and packing reasons some accessories may be supplied disassembled.
Make sure all components are present:
1) High-pressure machine itself
2) Chemical Tank
3) Electrical cord (attached)
4) High pressure hose with Lance Trigger
5) Water inlet male hose coupling
Machine Installation / Setup
Mount the high-pressure hose on to the High Pressure Cleaner by
pulling back the retainer on the high-pressure hose coupling, while
sliding it onto the male outlet of the unloader till a click sound could be
heard.
Assemble the double barrel spray-lance. To mount the
assembled spray-lance on to the Spray-gun trigger, pull
forward the front of the Spray-gun trigger (A) while
sliding in the male swivel coupling part of the spray-
lance. (B)
Prepare the water supply for the High Pressure Cleaner by attaching a
hose to the supplied low pressure inlet male-coupling. Connect the other
end of the water supply hose to a potable water tap. Turn on tap.
Connect to the public mains water supply in accordance to
regulations.
Notice
(A)
(B)
1
2
3
4
5