DENAGO commute 2 - Page 21

21
PAS LEVEL SELECTION
Short press the “UP” or “DOWN” button to switch the PAS level,
the motor output power will be changed accordingly by the PAS level of E-bike.
The default range of PAS level is 0-5 levels. Level 1 is the lowest output level, and the
level 5 is the highest output power level of the motor.
PAS Level Indicator
BATTERY INDICATOR
The battery power status is displayed in the form of grid. The indicator is divided into
ȴYHJULGV:KHQWKHSRZHULVORZWKHFRORUZLOOWXUQUHGWRUHPLQGWKHXVHUWRJHWWKH
battery charged.
Battery indicator
ERROR CODE
When the e-bike electronic control system fails, the display will automatically
LQGLFDWHWKHHUURUFRGH)RUWKHGHȴQLWLRQRIGHWDLOHGHUURUFRGHVVHHDSSHQGL[
7KHIDXOWFDQRQO\EHH[LWHGZKHQWKHIDXOWLVHOLPLQDWHGDQGWKH(ELNHFDQQRWFRQWLQXH
to drive after a fault occurs.
Error Code Indicator
USER SETTINGS
When there is no speed in the power on state, press and hold the “UP” and “DOWN”
button at the same time for 2 seconds, and the display will enter the setting interface.
Press “UP” or “DOWN” button to select display settings.
Setting List