3
FT Range SP20001_REV_2
Certifi cate of Conformity
Fine Turf (FT) Cylinder mowers powered by Honda GX Petrol Engine
Manufacturer:- Howardson Ltd, Howardson Works, Kirk Langley, Derby, DE6 4NJ. UK
Owner of Technical Document:- Mr I.D. Howard, Howardson Ltd, Howardson Works Kirk Langley, Derby, DE6 4NJ, UK
Notifi ed Body:- AV Technology Ltd, AVTECH house, Arkle Avenue, Stanley Green Trading Estate, Handforth, Cheshire,
SK9 3RW, UK
I the under signed Declare that these machines:-
The reliability and quality of performance of the DENNIS FT depends upon some simple care maintenance carried out
regularly. This manual has been prepared to allow the user to carry out all such work.
It is advisable to read the instructions carefully. Proper care and attention will enable the machine to give a continuous,
satisfactory, and reliable service. Failure to carry out regular lubrication and maintenance as outlined in this manual may
render any guarantee or warranty invalid.
In the case of any diffi culty, or if further information or advice is required, our Service Department is always at your call. In
the interests of speed and accuracy of information please quote the serial numbers of the machine and engine when
making enquiries.
For the mower, this is to be found on a plate attached to the side frame. The engine number is stamped on either the
crank case or the gear casing facing towards the front of the machine. We suggest you write the numbers on the front
page of this book.
Introduction
Serial Numbers
MACHINE SERIAL NUMBER
MAKE A NOTE OF THE SERIAL NUMBERS OF YOUR MACHINE & ENGINE AND ALWAYS
QUOTE THEM IN ANY COMMUNICATION WITH PERSONNEL AT DENNIS.
NOTE
ENGINE SERIAL NUMBER
Model Cutting Width Power (Honda)
Measured Sound Power
Level
Guaranteed Sound
Power Level
Serial Number
FT 430 17” (430mm) GX120 91dB Lwa 94dB Lwa See Product ID range
FT 510 20” (510mm) GX160 95dB Lwa 98dB Lwa See Product ID range
FT 610 24” (610mm) GX160 95dB Lwa 98dB Lwa See Product ID range
Tested at:- Howardson Works test site November 2009
Managing Director
Ian Howard
To Next Page
Loading...
