Dennis FT 430 - Page 8

8
FT Range SP20001_REV_2
STARTING THE ENGINE
Once the preparatory steps have been completed as outlined on page 7 the engine may be started. (See manufacturer
operating manual for full details).
1) Switch on the fuel tap.
2) Switch the handlebar cut off switch to ON, or depress deadmans handle (Item 1)
3) Set the throttle control to a half open position.
3) Shift the choke lever to the appropriate position (Kubota engine set to START : Honda engine set to the CLOSE
position). The choke is not required if the engine is warm or the air temperature high.
4) Grasp the recoil start handle until resistance is felt, then pull it with force.
5) Do not allow the starter grip to snap back against the engine. Return it gently to prevent damage to the starter.
6) Once the engine is started gradually ‘open’ the choke lever (move the lever towards the RUNNING, or OPEN
position). Warm-up running of 3-5 minutes is recommended.
STOPPING THE ENGINE
1) Set the throttle control to the CLOSED position.
2) Switch the handlebar cut off to OFF or release deadmans handle.
3) Close the fuel tap.
TO COMMENCE MOWING
With the starting preparations completed and all of the adjustments from the ‘General
Adjustments’ section made, the machine can be put into motion.
Firstly ensure the dog clutch is engaged. Open the throttle control on the left handlebar
which will engage the inertia clutch and spin the cassette reel. The engine speed
controls the rotational velocity of the cassette. Set the throttle to an approximately half
open position.
To engage the rear roller drive, gently raise the driving clutch lever on the right handle
bar (Item 2). The amount of depression on the lever dictates the speed of travel giving
the operator total control over the speed and handling of the mower.
When the handle is released the machine will stop. To stop the unit head rotating, reduce the throttle to tick over and this
will disengage the inertia clutch.
1
2
Operating Instructions