20
Controls
General
The system consists of two parts:
1. Saloon - heating provided by
convectors running along both
sides of the vehicle.
2. Cab and entrance area -
demisting, heating and ventilation
provided by radiator/fan unit
located below the LH front dash.
Permanently open outlets are
positioned across the front of the
dash for efficient windscreen
demisting.
A permanently open outlet is
positioned at floor level, in the
entrance area for heating and
ventilation.
Adjustable rotary vents are
positioned in the driver’s cab.
These provide heat or ventilation
to the cab or heat or ventilation to
the driver’s footwell . . . . . area.
Operation
Saloon Heating
Switch to On position.
Cab and Entrance Area
The temperature of the air delivered
through the outlets is controlled by
the slide control. This slide control
enables the air flow to be directed to
the windscreen demister outlets, the
adjustable vents or the entrance
/gangway outlet, or divided between
them.
Toggle Switch
The three position
switch (Off, Normal,
Boost) controls the
amount of air
delivered through the
outlets.
Heating & Ventilation
NOTE
Use Boost for initial warm up
or severe weather conditions
only. Using the Normal speed
will extend the life of the fan.
To Next Page
Loading...