Denon ADV-700

ENGLISH
67
(1) Setting the current time (12-hour display)
Example: To set the current time to “7:30 p.m.”
19
USING THE TIMER
1
Turn on the power.
ON / STANDBY
Main unit
2
Press the TIMER/SET button and hold it in for at least 2
seconds.
•“SET TIME” is displayed.
TIMER/SET
Main unit
✽ If the time is already set, “EVERYDAY” is displayed. Turn
the FUNCTION/SELECT dial to display “SET TIME”, then
continue on to step 3.
3
Press the TIMER/SET button.
•“Adj” is displayed and the hours’ place in the time display
flashes.
SET TIME
Adj. AM12:00
TIMER/SET
Main unit
4
Turn FUNCTION/SELECT dial to set the hours’ place to
“PM7”.
• The “PM7” flashes in the hours’ place.
Adj. PM7:00
FUNCTION
/SELECT
Main unit
5
Press the TIMER/SET button.
• The “PM7” in the hours’ place stops flashing, remaining lit,
and the minutes’ place starts flashing.
Adj. PM7:00
TIMER/SET
Main unit
6
Turn the FUNCTION/SELECT dial and set the minutes’ place
to “30”.
• The “30” flashes in the minutes’ place.
Adj. PM7:30
FUNCTION
/SELECT
Main unit
7
Press the TIMER/SET button to start the clock running.
• The time is set and the clock starts counting the time.
Time PM7:30
TIMER/SET
Main unit
✽ To check the current time when something else is
displayed, press the TIMER/SET button once. The current
time appears and remains displayed until another operation
is performed.
✽ When the TIMER/SET button is pressed again while the
time is displayed, after which the normal display reappears.
✽ The time can be displayed by pressing the TIMER/SET
button while the power is in the standby mode. (The power
is now no longer in the energy-saving standby mode.)
When the TIMER/SET button is pressed again while the
time is displayed, after which the display turns off and the
power is set back to the energy-saving standby mode.
1
c 8 1:02:46
DVD
TONE
2,3,5,71
4,6
Green