Denon AVC-A10H - Page 234

o
ZONE2/3
When “Amp Assign” is “11.1ch + ZONE2/3-MONO”, the speaker
terminal used for the ZONE2/3 speakers is displayed. Depending on
the settings of Main Zone speaker configuration, the terminal is
determined automatically.
HEIGHT 3:
The HEIGHT 3 speaker terminal is used
for the ZONE2/3 speakers.
HEIGHT 2:
The HEIGHT 2 speaker terminal is used
for the ZONE2/3 speakers.
SURROUND BACK:
The SURROUND BACK speaker
terminal is used for the ZONE2/3
speakers.
o
Settings
Select the signal to be output from the selected speaker terminal.
0
Only “Center” and “None” can be set for the CENTER speaker
terminal.
0
If you are using a total of seven or more Height/Ceiling/Dolby Atmos
Enabled speakers, you can only set “Top Middle”, “Surround Dolby”,
or “None” for the HEIGHT 3 speaker terminal.
0
You can use the HEIGHT 4/FRONT WIDE speaker terminals if you
are using the front wide speakers or if you are using a total of 7 or
more Height/Ceiling/Dolby Atmos Enabled speakers.
The HEIGHT 4/FRONT WIDE speaker terminals can only be set to
“Front Wide”, “Top Surround”, “Center Height”, “TS/CH” or “No”.
In addition, in order to set “Top Surround”, “Center Height” or
“TS/CH” on the HEIGHT 4/FRONT WIDE speaker terminals, “Top
Middle”, “Surround Dolby” or “Surround Height” must be set on the
HEIGHT 3 speaker terminal.
o
View Terminal Config.
This shows how to connect the speaker terminals and PRE OUT
connectors for your “Speaker Layout” setting on the menu screen.
Contents
Connections Playback Settings Tips Appendix
234
Front panel Display Rear panel Remote Index