Input the distances from the listening position to the speakers and set the surround delay time
Preparations:
Measure the distances from the listening position to the speakers (L1 to L3 on the diagram at the right)
LI: Distance from center speaker to listening position
L2: Distance from front speakers to listening position
Ls: Distance from surround speaker to listening position
CAUTION:
•_ Set the center speaker at the same distance from the front speakers (left and right) or the subwoofer,
or so that the difference in distance (L2 - L1) is 5 feet or less.
•_ Set the surround speakers (left and right) at the same distance from the front speakers (left and right)
or the subwoofer, or so that the difference in distance (L2 - L3) is 15 feet or less
FL Center FR
Listening
_ position
SL SR
1
Use the _ (left) and _ (right) buttons to set the distance from the front speakers and subwoofer to the
listening position.
[6 F::F;;:NT..":iii;Wi :2i:( l
• The number changes in units of 1foot each time one of the buttons is pressed. Select the value closest
to the measured distance.
("/SW" appears only when subwoofer = yes)
Press the SELECT or (_D (down) button to switch to the center speaker setting
NOTE:
• The speaker distance can be adjusted between 0 and 60 feet in steps of 1 foot.
2
Use the _ (left) and (_ (right) buttons to set the distance from the center speakers to the listening
position
L'?= ,"" E:"k, "r E:"E:= l
.....L...,, L..... i 2 "i:'"i.
• The number changes in units of 1foot each time one of the buttons is pressed. Select the value closest
to the measured distance.
Press the SELECT or _ (down) button to switch to the surround speaker setting.
NOTE:
• No setting when "None" has been selected for the center speaker
Use the (_D (left) and _ (right) buttons to set the distance from the surround speakers to the listening
position
.... • .....= ..= .. == .=...... = ...
• The number changes in units of 1foot each time one of the buttons is pressed. Select the value closest
to the measured distance.
Press the SELECT or [_[3 (down) button to enter the setting and switch the DIGITAL input (COAX) setting.
NOTE:
• No setting when "None" has been selected for the surround speakers
19
To Next Page
Loading...
