Denon AVR-1602

DENON and other makes of components can be operated by setting the preset memory for your make of video component
This remote control unit can be used to operate components of other manufacturers without using the learning function by registering the
manufacturer of the component as shown on the List of Preset Codes (pages 92, 93).
Operation is not possible for some models
f
@vGv©
IZI E]D C_ 13D
EB_ c_
-1
-2
-3
-2,3
Set the slide switch to "VIDEO". CD MO/COR
Holding in the SHWT button ,.1_, press the POWER
button @}of the components (DVD/VDP, VCR or TV) you
Press and hold in the SHIFT button.
Holding in the SHIFT button (3}, press the number
buttons {2} to input the preset code (consisting of 2-digit
numbers} for the manufacturer of the component
whose signals you want to store in the memory
See the list on pages 92 and 93for the preset codes
(consisting of 2-digit numbers).
--
To continue registering other components, repeat steps 2 to 3
NOTES:
• The signals for the pressed buttons are emitted while setting the preset memory. To avoid accidental operation, cover the remote control
unit's transmitting window while setting the preset memory
• Some models and years of manufacture of components of the manufacturers listed on the List of Preset Codes cannot be used
• The unit is equipped with several types of remote control codes which depend on the manufacturer. If there is no operation, please change
the preset code (a 2-digit number) and try again.
22