[_iKt]]![.t]][
[] REMOTE CONTROL UNIT
IQ _4._:__O
_GD_GD
ED_ _ _D
DENON
DENON remote-controllable audio components can be controlled using this unit's remote control unit.
Note that some components, however, cannot be operated with this remote control unit.
1
--2-C 2
Set the slide switch to the position for the component to
be operated (CD or MD/CDR)
CD MD/CDR
Use the buttons shown below to operate the audio component.
For details, refer to the respective component's manual.
a. For CD player and MD/CD recorder
44,1,_1,_ : Manual search (reverse and forward)
• : Stop
I,,,- : Play
14141,1b-I_1: Auto search
II : Pause
DISC SKIP+ : Switchdiscs(forCD changers only)
t2Y
b. For tape deck (TAPE)
44 : Rewind
I_1,_ : Fast4orward
• : Stop
I_ : Forward play
-,11 :Reverse play
c. For TUNER
SHIFT : Switch preset channel range
CHANNEL : Preset channel up/down
(+, -)
NOTE:
• Tape deck (TAPE) and tuner can be operated when the switch is at "AUDIO" position.
1
DENON
--1
DENON components can be operated by setting the preset memory for MD or CDR.
Operation is not possible for some models.
1
Set the slide switch to "MD/CDR".
CD MD/CDR
-2
2
Holding in the PLAY (1_) button, press the button for the
components you want to set (Refer to table 1 .)
Table 1: Combinations of Personal System
Codes
u_r_
C_
CDR
NOTE:
• The memory can only be preset for either the MD or the CDR.
•_ Preset codes set upon shipment from the factory and when reset
21
To Next Page
Loading...
