26
Calculation
Set up speakers (Audyssey
®
Setup)
11
Repeat step 10, measuring positions 3 to 8.
When measurement of position 8 is completed, a
“Measurements finished.” message is displayed.
Repeat Last Test
Audyssey Setup
Calculation
Measurements finished.
12
Select “Calculation” and then press ENTER.
Measuring results are analyzed, and the frequency response of
each speaker in the listening room is determined.
Audyssey Setup
Calibration completed! Now calculating...Please wait.
50%
•Analysis takes several minutes to complete. The more speakers
and measurement positions that there are, the more time it takes
to perform the analysis.
Measurement (2nd – 8th)
•In this step, you will perform measurements at multiple positions
(two to eight positions) other than the main listening position.
•Just one position can be measured but measuring multiple positions
increases the accuracy of the correction of acoustic distortion within
the listening area.
10
Move the setup microphone to position 2, select
“Continue”, and then press ENTER.
The measurement of the second position starts. Measurements
can be made in up to eight positions.
Audyssey Setup
Calculation
Repeat Last Test
Continue
Place the microphone at ear level at the 3rd listening position,
then select "Continue"...
Audyssey Setup
Calculation
Continue
Place the microphone at ear level at the 2nd listening position,
then select "Continue"...
•To skip measuring the third and subsequent listening position, use
ui to select “Calculation” and press ENTER to proceed to step
13.
•To measure the second position again, use ui to select “Repeat
Last Test” and press ENTER.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
