2
Press the button at which you want to store the system call
signals.
• The START LED flashes.
3
Set the mode switch to the position for the component
whose remote control signals you want to store.
2
Press the button whose settings you want to clear.
3
Press the SET button.
• The button is reset to the settings shown on the table on
page 29.
NOTES:
• The remote control signals for the buttons pressed while storing the system call signals are transmitted when the buttons are pressed, so
cover the remote sensor or take other measures so that the components do not operate while the signals are being stored.
• The LEARNED/TX LED does not light if system call signals cannot be stored at the button that you have pressed or if you have already stored
the maximum number of signals.
To Next Page
Loading...
Need help?
General
