Denon AVR-2807 - Page 7

- 7 -
COMMAND PARAMETER
function example
Z2 UP MULTI ZONE-2 VOLUME UP/DOWN , direct change to **dB Z2UP<CR>
DOWN at AVR-2807(Power Amp Assign=ZONE2 Only) Z2DOWN<CR>
** **:10 to 99 by ASCII , 80=0dB, 99=---(MIN) Z280<CR>
ON MULTI ZONE-2 ON/OFF change at AVR-2807 Z2ON<CR>
OFF Z2OFF<CR>
? Return Z2 Status Z2?<CR>
Z2MU ON ZONE2 OUTPUT MUTE ON/OFF change Z2MUON<CR>
OFF Z2MUOFF<CR>
? Return Z2MU Status Z2MU?<CR>
Z3 PHONO ---Invalid at AVR-2807 Z3PHONO<CR>
|  |
V.AUX Z3V.AUX<CR>
SOURCE ---Invalid at AVR-2807 Z3SOURCE<CR>
UP ---Invalid at AVR-2807 Z3UP<CR>
DOWN Z3DOWN<CR>
** Z380<CR>
ON ---Invalid at AVR-2807 Z3ON<CR>
OFF Z3OFF<CR>
? ---Invalid at AVR-2807 Z2?<CR>
Z3MU ON ---Invalid at AVR-2807 Z3MUON<CR>
OFF Z3MUOFF<CR>
? ---Invalid at AVR-2807 Z3MU?<CR>
SR PHONO REC SELECT mode set , and select source SRPHONO<CR>
| ---The name of PARAMETER is |
V.AUX the same as that of the time of SI COMMAND. SRV.AUX<CR>
SOURCE REC SELECT mode cancel SRSOURCE<CR>
? Return SR Status SR?<CR>
Z2 COMMAND : "*" parameter uses two ASCII characters. (see page4 J) section)