Denon AVR-3200

Playing
the analog
program source
Press
the button
for the
program
source
to be
played.
EX1: CD
.
Press
the button
once
to switch
the source
to
DAT/TAPE
in-
put, again
to
cancel
DAT/TAPE
input.
2
Select
the
ANALOG
input mode.
ANALOG
/DIGITAL
ANALOG/DITAL
:\
::
—
Lights
Check that
the “ANALOG”
indicator
is lit.
3
Start
playback
on the selected
component.
For
operating
instructions,
refer
to
the
various
components’
manuals.
4
Adjust the MASTER VOLUME
control.
III
I
II
The volume is indicated
on
the set’s
display.
BASS TREBLE
(d: (O:
Turn
the control
clockwise
to
increase the bass
or treble, coun
terclockwise to
decrease
it.
6
If the
indicator lights
when the “
OVER LOAD” LED is lit,
press
the ATTENUATOR
button.
.
The input
level is
lowered
by —6
dB.
Notes:
•
For
digital
input sources,
there
is
no
need to adjust
the
ATTENUATOR.
lThis
button
will
not
operate.)
•
If
the
indicator
does
not
turn off
when
this
button
is
pressed,
adjust
the output level
on the player.
•
This button
cannot be
used when
playing in
the
6—channel
EXT.IN
mode.
:
rr
EO
ERCU
f1I+-O
“
4
NGCR1[&
BASTER VOLUME
MASTER VOL.
I
cD
I
IDATrrAPE
MoNt
.
EX2:
DAT/TAPE
DAT/TAPE
MON
•
The
volume
can
be adjusted
in units
of 1
dB from —6Oto 0
to +18dB.
5
Adjust
the
BASS
and
TREBLE.
ATTENUATOR
ERROR!
OVERj
LOAD
4o
Light
25