What to do if my Denon Receiver power does not turn on?
If your Denon Receiver is not turning on, try these steps: * Make sure the power plug is fully and correctly inserted into the power outlet. * The protection circuit might be active. Disconnect the power plug from the outlet, wait 5 to 10 seconds, and then plug it back in.
How to enable sound from the subwoofer on Denon AVR-3313CI?
If you are not getting any sound from the subwoofer connected to your Denon Receiver, try the following: * Check the subwoofer connections to ensure they are properly connected. * Make sure the subwoofer is powered on. * In the menu, set “Speaker Config.” – “Subwoofer” to “Yes”. * If “Front” and “Center” for “Speaker Config.” are set to “Large”, and “Subwoofer Mode” is set to “LFE”, no sound may be output from the subwoofers, depending on the input signal or selected sound mode.
How to enable DTS sound output on Denon AVR-3313CI?
If DTS sound is not being output on your Denon Receiver, set “Decode Mode” in the menu to either “Auto” or “DTS.”
What to do if power indicator is blinking red after turning on Denon AVR-3313CI?
If, after turning on the power, the power indicator is blinking red in intervals of approximately 0.5 seconds, the unit's amplifier circuit has likely failed. Turn off the power and contact the DENON service advisor.
What to do if no video output with HDMI connection on my Denon Receiver?
If you are experiencing no video output with an HDMI connection on your Denon Receiver, consider the following: * Verify the HDMI connectors are properly connected. * Ensure the input source matches the connected HDMI connector. * Check if your TV supports copyright protection (HDCP). Incompatibility with HDCP can prevent proper video output. * If “HDMI Control” in the menu is set to “On”, try setting it to “Off”. When using the HDMI ZONE2 function, setting “HDMI Control” to “Off” may resolve the issue. * If the input source for ZONE2 is “SOURCE”, select a different input source than the one used for MAIN ZONE.
How to fix no audio output with HDMI connection on Denon Receiver?
If you are not getting any audio output with an HDMI connection on your Denon Receiver, here are a few things to try: * First, check the connection of the HDMI connectors to ensure they are properly connected. * If you want audio from the speakers, set “HDMI Audio Out” to “AVR” in the menu. * If you want audio from a TV, set “HDMI Audio Out” to “TV” in the menu.
How to improve radio reception on Denon AVR-3313CI Receiver?
If you're experiencing poor radio reception, noise, or distortion with your Denon Receiver, try these steps: * Adjust the antenna orientation or position. * Separate the AM loop antenna from the unit. * Consider using an FM outdoor antenna. * Keep the antenna separate from other connection cables.
How to turn on display on Denon AVR-3313CI?
If the display on your Denon Receiver is off, set “Dimmer” in the menu to something other than “Off.”
What to do if Denon AVR-3313CI Receiver does not operate properly?
If your Denon Receiver is not operating properly, try resetting the microprocessor.
Why does my Denon Receiver power automatically switch to standby mode?
Your Denon Receiver might be automatically switching to standby mode due to these reasons: * The sleep timer may be set. Turn the power on again, or adjust the sleep timer settings. * The “Auto Standby” feature is enabled, which triggers when there is no operation for a set time. To disable this, set “Auto Standby” to “Off” in the menu.
General| Receiver type | - |
|---|---|
| Audio output channels | 7.1 channels |
| Power output per channel (1KHz@6 Ohm) | 165 W |
| Power output per channel (20-20KHz@8 Ohm) | 125 W |
| HDMI in | 7 |
| Composite video in | 4 |
| Ethernet LAN (RJ-45) ports | 1 |
| Component video (YPbPr/YCbCr) in | 2 |
| Number of HDMI outputs | 3 |
| 12V trigger | Yes |
| Audio formats supported | AAC, FLAC, MP3, WMA |
| AM band range | 530 - 1710 kHz |
| FM band range | 87.5 - 107.9 MHz |
| Supported radio bands | AM, FM |
| Internet radio services supported | Pandora, SIRIUS Internet Radio, Spotify, vTuner |
| Product color | Black |
| Audio decoders | Dolby Digital Plus, Dolby Pro Logic IIz, Dolby TrueHD, DTS 96/24, DTS Digital Surround, DTS Neo:6, DTS-ES (Discrete 6.1), DTS-HD, DTS-HD Master Audio |
| Volume control | Rotary |
Weight and Dimensions| Depth | 378.9 mm |
|---|---|
| Width | 434.3 mm |
| Height | 166.8 mm |
| Weight | 11997 g |
To Next Page
