105
Playback
1
Press ZONE2 or ZONE3 to switch
the zone mode.
ZONE2 or ZONE3 lights.
Input source
select buttons
2
Press POWER X to turn on the
ZONE2 or ZONE3 power.
•Also press input source select button when
in standby mode, the power turns on.
•When POWER X is pressed, ZONE2 or
ZONE3 turns off.
•Power in ZONE2 or ZONE3 can be turned
on or off by pressing ZONE2 ON/OFF or
ZONE3 ON/OFF on the main unit.
3
Press the input source select
button to select the input source
to be played.
The audio signal of the selected source
is output to ZONE2 or ZONE3.
•To perform an operation with the main unit, press
ZONE2 SOURCE
SELECT
or ZONE3 SOURCE SELECT many times.
Each time you press ZONE2 SOURCE SELECT or ZONE3 SOURCE
SELECT
, the input source changes.
When power for both MAIN ZONE and ZONE2 (or ZONE3) is set to
ON, power of the MAIN ZONE only can be turned off. In Step 1, press
MAIN and POWER X in this order.
Adjusting the volume
Use VOLUME df to adjust the volume.
GAdjustable rangeH
0 – 40 – 98
(When the “Scale” (vpage116) setting is “0 – 98”)
GAdjustable rangeH
– – –
–79dB – –40dB – 18dB
(When the “Scale” (vpage116) setting is “–79.5dB – 18.0dB”)
•At time of purchase, “Volume Limit” (vpage 140) is set to “70
(–10dB)”.
Turn MASTER VOLUME after pressing ZONE2 SOURCE SELECT or
ZONE3 SOURCE SELECT on the main unit to adjust the sound volume.
Turning off the sound temporarily
Press MUTE :.
The sound is reduced to the level set at “Mute Level” (vpage140)
in the menu.
•To cancel, either adjust the volume or press MUTE : again.
•The setting can also be cancelled by adjusting the volume or turning
off the ZONE2 or ZONE3 power.
You can adjust the tone and volume for ZONE2 or ZONE3 in “ZONE2
Setup” or “ZONE3 Setup” (vpage140) in the menu.
Sleep timer function
•This is convenient for viewing and listening while going to sleep in
ZONE2 or ZONE3.
•The sleep timer function can be set by zone.
1
Press ZONE2 or ZONE3 to switch
the zone mode.
ZONE2 or ZONE3 lights.
2
Press SLEEP and display the time
you want to set.
•The time switches as shown below each time SLEEP is pressed.
6080 7090100
110
120
To confirm the countdown time before putting the
unit to sleep
Press SLEEP.
“Z2 Sleep : zmin” or “Z3 Sleep : zmin” appears on the display.
z Countdown time
To cancel the sleep timer
Press SLEEP to set “Off”.
The sleep timer is also cancelled when this unit is set to the standby
mode or the ZONE2 or ZONE3 power is turned off.
NOTE
The sleep timer function cannot turn off the power of devices
connected to this unit. To turn of the power of those connected
devices, set up sleep timers on the connected devices themselves.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
