Denon AVR-3803

Check that all the connections are correct, then turn on the main unit's power.
Display the System Setup Menu. System Setup Menu
_Speeker Configuration
Delay Time
Channel Level
Digital In Assignment
Video Setup
Dolby Digital Setup
Zone2 Control
• The composition of the signals output to the different channels and the frequency response are adjusted automatically according to the
combination of speakers actually being used.
1
At the System Setup Menu select "Speaker Configuration".
System Setup Menu
zSpeaker Configuration
Delay Time
Channel Level
Digital In Assignment
Video Setup
Dolby Digital Setup
Zone2 Control
__\ Switchtothespeakerconfigurationscreen.
Speaker Configuration
Set whether or not speakers are
connected and, if so, their size
parameters.
• To select the speaker
E_Front Sp.
Center Sp.
Subwoofer
"Speaker Configuration
Surround
_Sp. A
sp.SeN
i_iNN
• To select the parameter
G
Center Sp
Front Sp
Subwoofer
Surround Sp A
Surround back Sp
Surround Sp B
Press the ENTER button to finalize the setting.
NOTE: I
Select "Large" or "Small" not according to the actual size of the speaker but according to the speaker's capacity for playing low frequency
(bass sound below frequency set for the Crossover Frequency mode and below) signals. If you do not know, try comparing the sound at both
sett ngs sett ng the vo ume to a eve ow enough so as not to damage the speakers to determ ne the proper sett ng.
18