Select the play mode.
Example: Stereo
8UF_QUND SELECT
MODE _O _
(Main unit)
_E_O
(Remote control unit)
To select the surround mode while adjusting the surround
parameters, channel volume or tone control, press the
surround mode button then operate the selector.
SURROUND
MO_E
{Mainunit)
Start playback on the selected component.
• For operating instructions, refer to the component's
manual.
Adjust the volume.
r'_AS_ERV0LUME @
The volume level is
d_splayed on lhe (Main unit) (Remote corltro_ unit)
rnaste_ volume _evel
display
'_ The volume can be adjusted within the range of -80 to 0 to 18 dB,
in steps of 0.5 dB. However, when the channel level is set as
described on page 22 or pages 55 and 56, if the volume for any
channel is set at +1 dB or greater, the volume cannot be adjusted
up to 18 dB. {In this case the maximum volume adjustment range
is "18 dB -- {Maximum value of channel level)".}
Input mode when playing DTS sources
• Noise will be output if DTS compatible CDs or LDs are played in the
"ANALOG" or "PCM" mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL}
and set the input mode to "DTS".
Input mode display
• in the AUTO mode
INPUT
_UT9 PCM DTS
o o o
• in the DIGITAL PCM mode
_NPUT
AUTO \P_ DTS
O O O
/i \
• in the DIGITAL DTS mode
_NPUT
AUTO PCM @TS/
o o o
/i \
• in the ANALOG mode
INPUT
AUTO PCM DTS
o o o
One of these Hghts, depending on the
input slgna_
Input signal display
• DOLBY DIGITAL
E_
O
• DTS
OIGITAL
© C
• PCM
DIG TAL _
© ©
The _ indicator lights when digital signals are being input
properly. If the _ indicator does not light, check whether
the digital input component setup {page 24) and connections are
correct and whether the component's power is turned on.
NOTE:
• The _ indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound wifl be
heard.
49
To Next Page
Loading...
