Denon AVR-3803

[] CONNECTIONS
• DO not plug in the AC cord until all connections have been
completed.
• Be sure to connect the left and right channels properly (left with
left, right with right).
• Insert the plugs securely. Incomplete connections will result in the
generation of noise.
• Use the AC OUTLETS for audio equipment only. Do not use
them for hair driers, etc.
• Note that binding pin plug cords together with AC cords or placing
them near a power transformer will result in generating hum or
other noise.
• Noise or humming may be generated if a connected audio
equipment is used independently without turning the power of this
unit on. If this happens, turn on the power of the this unit.
• When making connections, also refer to the operating instructions of the other components.
The power to these outlets is turned on and off when the power is switched between on and standby from the remote control unit or power
switch.
OUTI_UT CD player
Turntable
(MM cartridge)
Connecting a turntable ]
Conrlect the tulntabJe's output cord to the AVR
3803/1083's PHONO iacks, the L (_eft) plug to the L
jack the R (right) plug to the right iack
If humrrfing or othel noise is generated when the
ground w_re is connected, disconnect the ground
w_re
Ground w_re
{Connecting the AC OUTLETS ]
AC OUTLETS
• SWITCHED
(total capacity /20 W {1 A ))
The power to these Outlets Js turned on arid off in coniunct_on w_th the
POWER operation switch on the main unit, and when the power is switched
between on and standby from the remote control unit
NO power is supplied from these outlet s when this unit's
Never connect equipment whose total capacity is above 120 W (1 A )
NOTE:
Only use the AC OUTLETS for audio equ_prnent Never use them fol 11
driers, TVs o_ othe_ electrical appliances
g the pre-out jacks
Use these iacks if you wish to connect external power amplifier(s) to
increase the power of the e0nt, centeI and surlound sound char/nels, Or
fol connect_Or t to powered loudspeakers
TO use Surround bac_, with one speaker, corlnect the speaker to
SURR BACKLCH
CD player or othel component
equipped with d_gital output jacks
[-- 0o0o!
(_oo [o } O O
OLrFpUT
MD recoider_ CD iecorder or other component
equlpped w_th digita_ input/output jacks
[ Connecting the DIGITAL jacks ]
Use these for coi!nections to audio equipment with digital output Refel to page 24 for
instruct_oiis oil setting tills tetmina_
Route the connection cords, etc, in such a _
way that they do not obstruct the ventilation AC 120 V 60 Hz
holes
[TRIGGER OUT]
Turn the DC 12V voRage on and off for the _lld_vidual functions
For detai_s, see "Sett_rlg the Trigger Setup" on page 31
CD recorder or Tape deck
R L R C 0oo _ _@
_NPUT OUTI_U r _
NOTE:
away
Connecting a tape deck]
Connections for recording:
Connect tile tape deck's recording fflpu_ iacks (LINE _N or REC) to this url_t's tape
recording {CDR/TAPE OUT) jacks using pin plug cords
Connections for playback:
Connect the tape deck's playback output jacks (LINE OUT or PB) to this url_t's tape
playback (CDR/TAPE IN) jacks using pin plug cords
6