- 10 -
EVENT PARAMETER function example
TF UP TUNER Frequency UP/DOWN , direct change TFUP<CR> *
DOWN TFDOWN<CR> *
****** (6 digits)
--- ****.** kHz at AM band (>050000 is AM.)
****.** MHz at FM band (<050000 is FM.)
TF105000<CR>
(1050.00kHz at AM)
*
XM*** (3 digits) --- *** CH at XM band TFXM001<CR>
(XM001 CH at XM)
*
TP UP TUNER PRESET CH UP/DOWN , direct change to No.** TPUP<CR> *
DOWN TPDOWN<CR> *
**(PRESET No.) TPA1<CR>
(PRESET No.”A1”)
*
MEMORY PRESET MEMORY TPMEMORY<CR> *
TM TUNER BAND , MODE Select *
AM ---Band set to AM TMAM<CR> *
FM ---Band set to FM TMFM<CR> *
XM ---Band set to FM TMXM<CR> *
AUTO ---Tuning mode set to AUTO mode TMAUTO<CR> *
MANUAL ---Tuning mode set to MANUAL mode TMMANUAL<CR> *
TF, TP, TM COMMAND : '*' parameters can NOT operate when INPUT source isn’t TUNER.
EVENT PARAMETER function example
SY REMOTE LOCK ON REMOTE CONTROL LOCK ON/OFF SYREMOTE LOCK ON<CR>
REMOTE LOCK OFF SYREMOTE LOCK OFF<CR>
PANEL LOCK ON PANEL BUTTON(Except MASTER VOL.)CONTROL LOCK ON SYPANEL LOCK ON<CR>
PANEL+V LOCK ON PANEL BUTTON & MASTER VOL. CONTROL LOCK ON SYPANEL+V LOCK ON<CR>
PANEL LOCK OFF PANEL BUTTUM & MASTER VOL. CONTROL LOCK OFF SYPANEL LOCK OFF<CR>
To Next Page
Loading...
Need help?
General
