Denon AVR-4208 User Manual

20
ENGLISH
The included remote control unit is equipped with a system call function allowing a series of remote control
signals to be transmitted by pressing a single button.
This function can be used for example to turn on the amplifier’s power, select the input source, turn on the
monitor TV’s power, turn on the source component’s power and set the source to the play mode, all at the touch
of a button.
System call
1
Press the power ON/SOURCE button and the OFF button at
the same time. “SET UP” appears on the remote control
unit’s display.
OFF
ON /
SOURCE
2
Press the ENTER button.
ENTER / SHIFT
SELECT
3
Use the D and H cursor buttons to display “SYS CALL” on
the remote control unit, then press the ENTER button.
• Display “SYSCALL1” on the remote control unit’s display.
1
5
3, 4
2, 3, 6
BAND MODE
TUNING
TUNING
ENTER / SHIFT
SELECT
(1) System call buttons
System call signals can be stored at the CALL 1 and CALL 2
buttons.
29 successive operations can be set at each of these buttons.
(2) Storing system call signals
4
When “SYSCALL1” is displayed, the remote control unit’s
display switches as shown below each time the D and H
cursor buttons are pressed.
BAND MODE
TUNING
TUNING
SYSCALL 1 SYSCALL 2
When “SYSCALL1” or “SYSCALL2” is selected, the signals
are stored at the SYSTEM CALL 1 and CALL 2 buttons
(green), regardless of the mode. When the enter button is
pressed “ENTER KEYS” is displayed, then the mode display
appears.
5
q Press the mode selector button according to
the button with the remote control signals to
be registered.
w Press the buttons with the remote control
signals to be registered one at a time.
6
Press the ENTER button.
•“COMPLETE” appears on the
remote control unit’s display and
registration is completed.
ENTER / SHIFT
SELECT
NOTES:
• The remote control signals of the buttons pressed while registering the system call signals are emitted, so
be careful not to operate the components accidentally (cover the remote sensors, for example).
• If you exceed the number of signals that can be registered, “FULL” appears on the remote control unit’s
display and only the number of signals that can be registered are registered (up to 29 operations).
1
Press the button at which the system call signals have been stored.
• The stored signals are transmitted successively.
(3) Using the system call function
Resetting
1
Press the power ON/SOURCE button and the
OFF button at the same time.
•“SET UP” appears on the remote control
unit’s display.
OFF
ON /
SOURCE
2
Press the ENTER button.
ENTER / SHIFT
SELECT
3
Use the D and H cursor buttons to display
“RESET” on the remote control unit, then press
the ENTER button.
BAND MODE
TUNING
TUNING
ENTER / SHIFT
SELECT
(1) Resetting the system call buttons
1
3, 4, 5
2, 3, 4, 5, 6

Denon AVR-4208 Specifications

General

Brand	Denon
Model	AVR-4208
Category	Amplifier
Language	English