Denon AVR-4208 User Manual

27
ENGLISH
10
SURROUND
Before playing with the surround function
• Before playing with the surround function, be sure to use the test tones to adjust the playback level from the
different speakers. This adjustment can be performed with the system setup (see page 14) or from the remote
control unit, as described below.
• Adjusting with the remote control unit using the test tones is only possible in the “Auto” mode and only
effective in the DOLBY/DTS SURROUND and HOME THX CINEMA modes. The adjusted levels for the
different modes are automatically stored in the memory.
2
1, 3
1
Press the TEST TONE button.
TEST
TONE
• After adjusting using the test tones, make the desired settings for each surround mode to be played, then use
the procedure described below to adjust the levels of the various channels.
FL C FR SR SBR SBL
SLSW
FADER
1
Press the CH VOL button (or the SELECT
button on the remote control unit) and select
“CH VOL”.
CH VOL
(Main unit)
2
2
1
21
(Remote control unit)
2
Test tones are output from
the different speakers. Use
the channel volume adjust
buttons to adjust so that the
volume of the test tones is
the same for all the speakers.
BAND MODE
TUNING
TUNING
(Remote control unit)
3
After completing the
adjustment, press the TEST
TONE button again.
TEST
TONE
(Remote control unit)
ENTER / SHIFT
SELECT
(Remote control unit)
The setting mode switches in the following
order each time the button is pressed.
Adjust the level of the selected speaker.
SELECT
(Main unit)
BAND MODE
TUNING
TUNING
(Remote control unit)
When the surround back speaker setting is set
to “1spkr” for “Speaker Configuration”, this is
set to “SB”.
NOTES:
• The adjustment range for the different channels
is +12 dB to –12 dB.
• When using the DIRECT mode, the sound from
the subwoofer can be cut by lowering the SW
(subwoofer) setting one step from –12 dB
(setting it to “OFF”).
Fader function
• This function makes it possible to lower the volume of the front channels (FL, C and FR) or the rear channels
(SL, SR, SBL and SBR) together. Use it for example to adjust the balance of the sound from the different
positions when playing multi-channel music sources.
FL C FR SR SBR SBL
SLSW
FADER
1
Press the CH VOL button (or the SELECT
button on the remote control unit) and select
“FADER”.
CH VOL
(Main unit)
2
1
21
ENTER / SHIFT
SELECT
(Remote control unit)
The channel switches in the order shown
below each time the button is pressed.
2
MAIN UNIT:
Turn the SELECT knob
clockwise to adjust the
volume of the surround side
collectively.
Turn the SELECT knob
counterclockwise to adjust
the volume of the front side
collectively.
REMOTE CONTROL UNIT:
Press the D button to adjust
the volume of the surround
side collectively.
Press the H button to adjust
the volume of the front side
collectively.
SELECT
(Main unit)
BAND MODE
TUNING
TUNING
(Remote control unit)
The fader function does not affect the SW
channel.
The channel whose channel level is adjusted
lowest can be faded to –12 dB using the fader
function.
If the channel levels are adjusted separately after
adjusting the fader, the fader adjustment values
are cleared, so adjust the fader again.
This is only displayed when setting the fader control.

Denon AVR-4208 Specifications

General

Brand	Denon
Model	AVR-4208
Category	Amplifier
Language	English