Denon AVR 4308CI - AV Network Receiver - Page 37

- 37 -
EVENT PARAMETER
function example
Z3 PHONO MULTI ZONE-3 source change Z3PHONO<CR>
| ---The name of PARAMETER is |
POD the same as that of the time of SI COMMAND. Z3IPOD<CR>
SOURCE MULTI ZONE-3 mode cancel Z3SOURCE<CR>
** MULTI ZONE-3 VOLUME change , **:10 to 99 by ASCII Z380<CR>
98 = +18dB(MAX)
80 = 0dB
10 = -70dB
99 = ---(MIN)
ON MULTI ZONE-3 ON/OFF change Z3ON<CR>
OFF Z3OFF<CR>
Z3MU ON ZONE3 OUTPUT MUTE ON/OFF change Z3MUON<CR>
OFF Z3MUOFF<CR>
Z3CS ST
ZONE3 Channel setting
Z3CSST
MONO Z3CSMONO
Z3CV FL **
**:38 to 62 by ASCII , 50=0dB
Z3CVFL 50<CR>
FR **
**:38 to 62 by ASCII , 50=0dB
Z3CVFR 50<CR>
Z3HPF ON
ZONE3 HPF ON/OFF change
Z3HPFON<CR>
OFF Z3HPFOFF<CR>
Z3PS BAS **
ZONE3 BASS change
Z3PSBAS 00<CR>
TRE **
ZONE3 TEBLE change
Z3PSTRE 00<CR>
Z4 CD
MULTI ZONE-4 source change
Z4CD<CR>
|
---The name of PARAMETER is
|
V.AUX
the same as that of the time of SI COMMAND.
Z4V.AUX<CR>
SOURCE
MULTI ZONE-4 mode cancel
Z4SOURCE<CR>
ON
MULTI ZONE-4 ON/OFF change
Z4ON<CR>
OFF Z4OFF<CR>
The PARAMETER of Z3 EVENT : Uses two ASCII characters. (see page4 J) section)