Denon AVR-5805 - Page 12

29.Mar.06
12/25
COMMAND PARAMETER
function example
PS
ROOM EQ:AUDYSSEY
ROOM EQ mode direct change
PSROOM EQ:AUDYSSEY<CR>
ROOM EQ:FRONT PSROOM EQ:FRONT<CR>
ROOM EQ:FLAT PSROOM EQ:FLAT<CR>
ROOM EQ:MANUAL PSROOM EQ:MANUAL<CR>
ROOM EQ:OFF PSROOM EQ:OFF<CR>
DELAY UP
AUDIO DELAY UP/DOWN , direct change to ***dB
PSDELAY UP<CR>
DELAY DOWN
***:000 to 999 by ASCII , 000=0ms, 200=200ms
PSDELAY DOWN<CR>
DELAY ***
---AVR5805 can be operated from 0 to 200
PSDELAY 200<CR>
TF UP TUNER Frequency UP/DOWN , direct change TFUP<CR> *
DOWN TFDOWN<CR> *
****** (6 digits) --- ****.** kHz at AM band (>050000 is AM.)
****.** MHz at FM band (<050000 is FM.)
TF105000<CR>
(1050.00kHz at AM)
TP UP TUNER PRESET CH UP/DOWN , direct change to No.** TPUP<CR>
DOWN TPDOWN<CR>
**(PRESET No.) TPA1<CR>
(PRESET No.”A1”)
TM TUNER BAND , MODE Select
AM ---Band set to AM TMAM<CR>
FM ---Band set to FM TMFM<CR>
AUTO ---Tuning mode set to AUTO mode TMAUTO<CR> *
MANUAL ---Tuning mode set to MANUAL mode TMMANUAL<CR> *
TF, TP, TM COMMAND : '*' parameters can NOT operate when INPUT source isn’t TUNER.
The BOLD COMMANDS are new.