29.Mar.06
14/25
COMMAND PARAMETER
function example
Z2 PHONO MULTI ZONE-2 mode set , and select source Z2PHONO<CR>
| ---The name of PARAMETER is |
CDR/TAPE
the same as that of the time of SI COMMAND.
Z2CDR/TAPE<CR>
SOURCE MULTI ZONE-2 mode cancel Z2SOURCE<CR>
UP MULTI ZONE-2 VOLUME UP/DOWN , direct change to ***dB Z2UP<CR>
DOWN Z2DOWN<CR>
** **:00 to 99 by ASCII , 80=0dB, 99=---(MIN) Z280<CR>
ON MULTI ZONE-2 ON/OFF change Z2ON<CR>
OFF Z2OFF<CR>
Z2MU ON
ZONE2 OUTPUT MUTE ON/OFF change Z2MUON<CR>
OFF
Z2MUOFF<CR>
Z2SV DVD
ZONE2 VIDEO SELECT mode set , and select source
Z2SVDVD<CR>
VDP
Z2SVVDP<CR>
TV
Z2SVTV<CR>
DBS
Z2SVDBS<CR>
VCR-1
Z2SVVCR-1<CR>
VCR-2
Z2SVVCR-2<CR>
VCR-3
Z2SVVCR-3<CR>
VCR-4
Z2SVVCR-4<CR>
V.AUX
Z2SVV.AUX<CR>
SOURCE
ZONE2 VIDEO SELECT mode cancel
Z2SVSOURCE<CR>
Z2SD AUTO
MULTI ZONE-2 set DIGITAL INPUT AUTO mode
Z2SDAUTO<CR>
ANALOG
MULTI ZONE-2 set force ANALOG INPUT mode
Z2SDANALOG<CR>
Z2 COMMAND : "*" parameter uses two or three ASCII characters. (see page4 J) section)
The BOLD COMMANDS are new.
To Next Page
Loading...
