Denon AVR-5805 - Remote Control Unit Operations

29.Mar.06
25/25
EVENT PARAMETER
function example *RES.
Z2PS DELAY UP
AUDIO DELAY change, ***:000 to 999 by ASCII
Z2PSDELAY UP<CR>
DELAY DOWN
---AVR5805：200=200ms（MAX）
Z2PSDELAY DOWN<CR>
DELAY ***
100=100ms, 000=0ms
Z2PSDELAY 200<CR>
Z3 PHONO
MULTI ZONE-3 source change
Z3PHONO<CR>
|
---The name of PARAMETER is
|
CDR/TAPE
the same as that of the time of SI COMMAND.
Z3CDR/TAPE<CR>
SOURCE
MULTI ZONE-3 mode cancel
Z3SOURCE<CR>
**
MULTI ZONE-3 VOLUME change , **:00 to 99 by ASCII
Z380<CR>
98 = +18dB(MAX)
80 = 0dB
00 = -80dB
99 = ---(MIN)
ON
MULTI ZONE-3 ON/OFF change
Z3ON<CR>
OFF Z3OFF<CR>
Z3MU ON
ZONE3 OUTPUT MUTE ON/OFF change
Z2MUON<CR>
OFF Z2MUOFF<CR>
Z4 PHONO
MULTI ZONE-4 source change
Z4PHONO<CR>
|
---The name of PARAMETER is
|
CDR/TAPE
the same as that of the time of SI COMMAND.
Z4CDR/TAPE<CR>
SOURCE
MULTI ZONE-4 mode cancel
Z4SOURCE<CR>
**
MULTI ZONE-4 VOLUME change , **:00 to 99 by ASCII
Z480<CR>
98 = +18dB(MAX)
80 = 0dB
00 = -80dB
99 = ---(MIN)
ON
MULTI ZONE-4 ON/OFF change
Z4ON<CR>
OFF Z4OFF<CR>
Z4MU ON
ZONE4 OUTPUT MUTE ON/OFF change
Z2MUON<CR>
OFF Z2MUOFF<CR>
SR PHONO REC SELECT source change SRPHONO<CR>
| ---The name of PARAMETER is |
CDR/TAPE
the same as that of the time of SI COMMAND.
SRCDR/TAPE<CR>
SOURCE REC SELECT mode cancel SRSOURCE<CR>
*RES. : NOT returns '*' parameters as RESPONSE.
The PARAMETER of Z3, Z4 EVENT : Uses two or three ASCII characters. (see page4 J) section)