Getting Started Connections Setup Playback Remote Control Information Troubleshooting
ENGLISH
Specifi cations
Multi-zone Operations
Turning the Power On and Off
GOperation on the main unitH
Press <ZONE2 ON/OFF> for the zone to be operated.
GOperation on the remote control unitH
Press [ZONE2 ON] or [ZONE2 OFF].
Selecting the Input Source
GOperation on the main unitH
Press <ZONE2 / REC SELECT>, then turn <SOURCE SELECT>.
GOperation on the remote control unitH
Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE CONTROL 2] to
“ZONE2”.
Press [SOURCE SELECT].
Adjusting the Volume
Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE CONTROL 2] to
“ZONE2”.
Press [VOLUME].
– – –
–70dB
~
–40dB
~
+18dB[Variable range]
The ZONE2 volume can be adjusted only when “ZONE2” is selected
at “System Setup” – “Option Setup” – “Amp Assign” (vpage 28).
<ZONE2 ON/OFF>
<ZONE2 / REC SELECT>
<SOURCE SELECT>
[SOURCE
CONTROL 1]
[SOURCE
CONTROL 2]
[SOURCE
SELECT]
[VOLUME]
[MUTING]
Turning off the Sound Temporarily
Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE CONTROL 2] to
“ZONE2”.
Press [MUTING].
b To cancel, either adjust the volume or press [MUTING] again.
The setting is canceled when the zone’s power is turned off.
The source selected for ZONE2 is also output from the recording
output connectors.
NOTE
Digital audio signals input from the COAXIAL or OPTICAL connectors
cannot be played in multi-zone.
[ZONE2 ON]
[SOURCE
SELECT]
[ZONE2 OFF]
[MAIN OFF]
[MAIN ON]
[Front] [Rear]
Button located on both the main unit and the remote control
unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
When using ZONE2, it is possible to turn the power for the MAIN
ZONE only on or off by pressing [MAIN ON] or [MAIN OFF].
Multi-Zone
With ZONE2, only the
buttons indicated in this
illustration can be operated.
NOTE
Buttons other than these
cannot be operated.
To Next Page
Loading...
