Denon AVR 689 - AV Receiver - 2-Channel Playback Customization; 2 ch Direct;Stereo Customization; Subwoofer & Distance Settings (2 ch); Crossover Frequency (2 ch)

Specifications

For details on how to select, set and cancel settings for each menu, see “System setup operation” (vpage 22).
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
ENGLISH
j ZONE2 Mute Level
This sets the amount of attenuation of the volume when the mute
mode is set in the ZONE2.
[Selectable items]
Full
: The sound is cut off entirely.
–40dB
: The sound is attenuated by 40 dB.
–20dB
: The sound is attenuated by 20 dB.
h ZONE2 Power On Level
This sets the volume set when the ZONE2’s power is turned on.
[Selectable items]
Last
: Use the memorized setting from the last session.
– – –
: Always use the muting on condition when power
is turned on.
[Variable range]
–70dB ~ +18dB
: Set the volume level when the power is turned on
in units of 1 dB.
b The variable level when upper limit has been set with “Volume
Limit” is “–70 dB ~ the set volume level”.
k ~ A4 2ch Direct/Stereo Custom
Make speaker settings for 2-channel mode playback.
k Setting
To change the settings, select “ON”.
[Selectable items]
OFF
: Use the same settings as in “Speaker Setup”.
ON
: Make separate settings for 2-channel mode.
l Front
Select front speaker size.
[Selectable items]
Large Small
: Select front speaker size.
A4 Crossover
Select crossover frequency from which subwoofer handles low range
signal.
[Selectable items]
40Hz 60Hz 80Hz 90Hz 100Hz 110Hz 120Hz 150Hz
200Hz 250Hz
: Select crossover frequency.
A2 Distance FL
Set distance from listening position to front left speaker.
[Variable range]
0ft ~ 60ft
A3 Distance FR
Set distance from listening position to front right speaker.
[Variable range]
0ft ~ 60ft
A1 Subwoofer Mode
Select low range signal to be reproduced by subwoofer.
[Selectable items]
Norm +Main
: Select subwoofer signal.
A0 Subwoofer
Select subwoofer use.
[Selectable items]
Yes No
: Select subwoofer use.
[Display]
1 . S p 2 . I n 3 . O p
E
O p t i o n S e t u p
E
8 2 c h C s t m : O F F
E
8 2 c h C s t m : O N
E
9 2 c h F : L a r g e
E
1 0 2 c h S W : Y e s
E
1 1 2 c h L F E : N o r m
E
1 2 2 c h F L : 1 2 f t
E
1 3 2 c h F R : 1 2 f t
E
1 4 2 c h F r e q : 8 0
“ZONE2 Volume Control” is displayed when “ZONE2” is selected
with “Amp Assign” (vpage 28).