Denon AVR-750 User Manual

4-6 Recording the program source
{recording the source currently being monitored)
© Follow steps @ to © under “Playing the program source”.
(reter to page 9)
Simultaneous recording
Tha signals of the source selected with the function selector button are output simultaneously to the DAT/TAPE and VCR REC OUT
jacks. If a total of two tape and/or video decks are connected and set to the recording mode, the same source can be recorded
simuRaneousty on both decks.
© Start recording on the tape or video deck.
For Instructions, refer to the component's operating instructions.
In addition, if the TAPE MONITOR (DAT/TAPE) button is pressed, the audio signals from the tape deck are output to the VCR
AUDIO REC OUT jacks.
47 Front panel display
Descriptions of the unit's operations are also displayed on the front panel display. In addition, the display can be switched to check the
unit's operating status while playing a source by pressing the PANEL button.
48 Using the surround function
Types of surround modes and their characteristics
[ 1 | OOLBYPROLOGIC Use this when playing program sources recorded in Dolby Surround or Dolby Stereo.
CONCERT HALL Use this setting to create the atmosphere of a concert hall.
There will be no output from the center speaker.
Use this setting to create the atmosphere of watching a live performance.
There will be no output from the center speaker.
* Before using the surround function
Make the following adjustments before using the surround
function.
@ Sat the Dolby Pro Logic mode.
Is &
© Select the centers mode (refer to page 11).
Select the center mode according to the center speaker.
———— aN NORMAL —> PHANTOM
wouy capmen
eel
The mode changes ae shown above.
© Emit the test tone.
T.TONE
© Tum the test tone off.
{rear)
levels
to
sat
the
volume
of
T.TONE
the speakers to the same level.
© Adjust the center and surround
Test tones are produced from the speakers
in
the
order
shown
below,
at
4
second
" 7 .
intervals
for
the
first
two
cycles,
2
second
cEnTEA
©
Adjust
the
delay
time
and
seating
intervais
after
that.
ora
as
necessary
(refer
to
page
fice
Mees
ee
10
Center Mode
Set the center mode as described below, according to the type of
center speaker being used.
Norma! mode: This mode is suited for an arrangement In which
the center channe! speaker is smailer than the left and right
speakers. Signais below 100 Hz which have almost no effect on
directional orientation are distributed to the left and right channels,
whereas the center channel output signals greater than 100Hz. As
8 result, the bass of the teft and right channels Increases the
apparent deepness of the sound.
Wide mode: This mode js suited for an arrangement in which the
center channel speaker is of the same grade as the left and right
speakers. The entire sound band from tow region to high Is output
to the center channel to provide an exciting sound field for your
enjoyment.
Phantom mode: Use this mode when center channel speaker is
not used. A directional emphasis circuit provides signal
reproduction which Is electrically orlented to the center and this
provides an exciting sound field for your enjoyment.
Dolby Surround systems with Pro Logic decoding most closely
replicate the Dolby Stereo theatrical experience. Only two surround
speakers are necessary in the home listening environment to provide
the same enveloping soundfield as multiple surround speakers in the
Delay Time
The optimum delay time will differ depending on the listening
position. Referring to the chart at lett, set the optimum delay time
for your room's space and seating position. For example, when
the distance from the front speakers to the listening position is 20
feat and that from the surround (rear) speakers to the listening
position is 15 feet, the optimum delay time will be 21 ms.
The variabie range of the delay time differs depending on the
mode.
0 5 1 1% 2 2 % 95
DISTANCE FROM FRONT SPEAKERS (FEET) [_]NOT RECOMMENDED
USABLE SPEAKER PLACEMENT RANGE WITH
([Xims) DELAY TIME
Personal Memory Plus function . ... for EASY TO USE
The AVA-750/760/770/780 automatically stores the surround mode adding effects for all input sources. The corresponding surround
mode is recalied automatically each time an input source is selected.
¢ Using the surround function
@ Select the surround mode according to the Input source.
2B; C -Y
© \f necessary, adjust the levels.
© Adjust the parameters to the desired settings.
DELAY
Manufactured under license from Dolby Laboratories Licensing Corporation.
“Dolby”, “Pro Logic” and the double-D symbol are trademarks of Dolby Laboratories Licensing
Corporation. Copyright 1992 Dolby Laboratories, Inc. Alt rights reserved.
an)
es OR L/OLL/O9SL/OSL-‘HAV Bl

Denon AVR-750 Specifications

General

Brand	Denon
Model	AVR-750
Category	Stereo Receiver
Language	English