Need help?Do you have a question about the Denon AVR-989 and is the answer not in the manual?
General| Channels | 7.1 |
|---|---|
| Total Harmonic Distortion (THD) | 0.05% |
| Frequency Response | 10 Hz - 100 kHz |
| Signal-to-Noise Ratio | 100 dB |
| HDMI Inputs | 3 |
| HDMI Outputs | 1 |
| Input Impedance | 47 kOhms |
| Input Sensitivity | 200 mV |
| Tuner Type | AM/FM |
| Digital Sound Processor (DSP) | Yes |
| DSP Presets | Multiple |
| HDMI Switching | Yes |
| Video Conversion/Scaling | Yes |
| HDMI Pass-Through | Yes |
| Tuner Bands | FM, AM |
| Additional Features | Audyssey MultEQ |
| Speaker Impedance | 4-16 ohms |
| Tuner Frequency Range | FM: 87.5 - 108 MHz |
| Dimensions (W x H x D) | 17.1 x 6.7 x 16.3 inches |
Warnings about opening the unit and referring to qualified personnel for servicing.
Instruction to avoid exposing the appliance to rain or moisture.
Identifies and explains the functions of the front panel controls and indicators.
Step-by-step instructions for connecting speaker cables to terminals.
Details connecting devices using HDMI, including compatibility and features.
Guides on connecting source devices like Blu-ray players and DVD players.
Instructions on how to connect the power cord safely.
Explains how to navigate and operate the AVR-989 using its menus.
Steps to prepare and connect the setup microphone for auto setup.
Details the speaker detection phase of the auto setup process.
Explains how to perform speaker measurements for auto setup.
Describes the analysis and calculation phase of auto setup.
How to review the measurement results and analysis from auto setup.
Instructions for saving the auto setup measurements and finishing the process.
How to review auto setup results again after completion.
Manually set speaker size, type, and configuration for each channel.
Adjust the volume level for each speaker channel to match output.
Configure HDMI output for color space, RGB range, and audio.
Configure audio settings for subwoofer level and 2-channel sources.
Adjust channel levels, volume limits, power-on, and mute levels for ZONE2.
Configure amplifier assignments and manage input sources.
Configure settings for various input sources like PHONO, TUNER, XM, SIRIUS, etc.
Choose how the AVR-989 interprets input signals (Auto, HDMI, Digital, Analog, EXT. IN).
Adjust audio input levels and assign sources to specific connectors.
Explains standard playback modes like PLIIx, PLII, and DTS NEO:6 for 2-channel sources.
Handles multi-channel formats and selects DSP simulation modes.
Adjust parameters like Mode, Cinema EQ, DRC, LFE, and others for surround sound.
Select sound modes, Cinema EQ, and adjust dynamic range compression.
Configure Audyssey settings like MultEQ XT, Bass, Treble, and Tone Control.
Select MultEQ XT room correction type and enable Dynamic EQ.
Adjust Dynamic Volume levels and select effect settings (Midnight, Evening, Day).
Configure amplifier assignments for multi-zone or bi-amp playback.
Common problems like no display, sudden power off, and no sound.
To Next Page
