Denon AVR-989 - ZONE2 and Option Setup; ZONE2 Level and Volume Controls; Option Setup Menu Overview


Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting
Specifications
For details on how to select, set and cancel settings for each menu, see “Menu Operations” (vpage 20).
[Selectable items]
OFF
: Do not set a maximum volume.
–20dB
: Set the maximum volume to –20 dB.
–10dB
: Set the maximum volume to –10 dB.
0dB
: Set the maximum volume to 0 dB.
[Selectable items]
Last
: Use the memorized setting from the last session.
– – –
: Always use the muting on condition when power
is turned on.
[Variable range]
–70dB ~ +18dB
: Set the volume level when the power is turned on
in units of 1 dB.
[Selectable items]
Full
: The sound is cut off entirely.
–40dB
: The sound is attenuated by 40 dB.
–20dB
: The sound is attenuated by 20 dB.
F Menu screen F
2.Manual Setup
2.HDMI Setup
1.Speaker Setup
4.ZONE2 Setup
5.Option Setup
3.Audio Setup
Option Setup
Make various other settings.
a Amp Assign
Define how the amplifier for the surround back speaker channels
is used.
The places where the surround back amplifier are used can be set
freely according to the usage environment. This makes it possible to
output sound to rooms other than the room (the MAIN ZONE) where
surround playback is performed (multi-zone playback) or play the sound
with high quality using the front speakers (bi-amp connections).
[Selectable items]
7.1ch
: The surround back channel is output from the
speakers connected to the SURR.BACK/AMP
ASSIGN terminals.
ZONE2
: When ZONE2 power is on, ZONE2 sound is
emitted from the speaker connected to the
SURR.BACK/AMP ASSIGN terminal.
FrontA Bi-Amp
: The Front A channel for Bi-Amp use is output
from the speakers connected to the SURR.
BACK/AMP ASSIGN terminals.
FrontB Bi-Amp
: The Front B channel for Bi-Amp use is output
from the speakers connected to the SURR.
BACK/AMP ASSIGN terminals.
2.Vol.Control
3.Source Delete
4.On-Screen Display
5.Quick Select Name
6.Trigger Out
7.Remote ID Setup
8.232C Port
9.Display
10.Setup Lock
1.Amp Assign
2-5.Option Setup
This can be set when “Volume Level” is set to “VAR“.
This can be set when “Volume Level” is set to “VAR“.
Setup
“VAR” is fixed when a power amplifier is assigned to the ZONE2
output channel at menu “Manual Setup” – “Option Setup” – “Amp
Assign” (vpage 32).
[Selectable items]
VAR
: Allow volume adjustment by remote control.
–40dB
: Fix the volume to –40 dB.
0dB
: Fix the volume to 0 dB.
d
Volume Level
Adjust the main volume level.
f
Volume Limit
Make a setting for maximum volume.
[Variable range]
–12dB
~
0dB
~
+12dB
s
Level Rch
Adjust the right channel output level.
g
Power On Level
Define the volume setting that is active when the power is turned
on.
h
Mute Level
Set the amount of attenuation when muting is on.
AVR989EU_ENG_080630.indd 32 2008/06/30 15:26:56