Denon AVR-987

26
Basic Operation Basic Operation
About the button names in this explanation
<>: Buttons on the main unit
[]: Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
D H F G
STANDARD
ENTER
SURROUND
PARAMETER
<STATUS>
<SURROUND BACK>
INPUT MODE
ENTER
D
H F G
Selecting the Dolby Digital and DTS
Surround mode (only with digital input)
Play a program source with the ,
mark.
•“ ” or “ ” lights, depending on the source.
Press SURROUND PARAMETER.
The surround back channel can be switched on and off using
<
SURROUND BACK
>
.
Press
DD HH
to select the item, then press
FF GG
to
set.
Press STANDARD to select “STANDARD”.
3
6
5
4
Select an input source forwhich digital (COAXIAL,
OPTICAL etc.) is set ( page 47 or 49 ~ 50).
1
Press INPUT MODE to select “AUTO”.
2
CINEMA EQ.:
Use this if movie dialogues sound harsh to lower the treble
sound.
Effective source / mode
Dolby Pro Logic IIx / Dolby Pro Logic / Dolby Digital /
DTS Surround / DTS NEO:6 / WIDE SCREEN
D.COMP.:
The dynamic range is compressed. Select one of 4 modes:
“OFF”, “LOW”, “MID” (middle) or “HI” (high).
Effective source / mode
Dolby Digital /
DTS (For DTS sources, only displayed for compatible
software.)
LFE:
To play the various types of software properly, we
recommend setting to the values shown below.
•To play Dolby Digital software: “0 dB”
•To play DTS movie software: “0 dB”
•To play DTS music software: “–10 dB”
TONE:
Adjust the tone control.
Can be set in surround modes other than direct mode.
Can be set separately for the different surround modes.
(Adjusted together for the Dolby/DTS SURROUND
modes.)
SB CH OUT:
Select the play mode or surround back channel playback
method.
(1) For multi-channel sources
• SB OFF (OFF):
Not played.
• NON MTRX:
Surround channel signal played.
• MTRX ON:
Surround channel signal played with digital matrix processing.
• ES MTRX:
DTS signal played with digital matrix processing.
• ES DSCRT:
Signal included in DTS-ES discrete 6.1-channel sources
played.
• PL
IIx CINEMA:
Decoded in Dolby Pro Logic IIx Cinema mode, surround back
signal played.
Set the surround back speaker to “2spkrs” at “Speaker
Configuration” ( page 56, 57)
• PLIIx MUSIC:
Decoded in Dolby Pro Logic IIx Music mode, surround back
signal played.
Set the surround back speaker to “1spkr” or “2spkrs” at
“Speaker Configuration” ( page 56, 57)
(2) For 2-channel sources
• OFF: Not played.
• ON: Surround channel signal played.
Can also be operated using
<
SURROUND BACK
>
.
5
Example: Dolby Digital Example: DTS
SURROUND
PARAMETER
STANDARD
INPUT MODE
D H F G
ENTER