Record Player
• When connecting a record player with an MC cartridge, use a
commercially available MC head amplifier or a step-up transformer.
• Induction humming (a booming sound) may be produced from the
speakers if the volume is raised with no record player connected.
• With some record players, noise may be generated when the ground
wire is connected. If so, disconnect the ground wire.
Turntable (MM cartridge)
NOTE
The AVR-988’s SIGNAL GND terminal is meant to reduce noise when a
record player is connected. This is not a safety ground terminal.
R
L
R
L
"6%*0
"6%*0
$0"9*"-
065
3-
065
CD Player
Connect the cables to be used.
CD player
When using an optical cable for the digital audio connection, make
the settings at menu “Input Setup” – “Assign” – “Digital In” (vpage
35).
ConnectionsGetting Started Setup Playback Remote Control Multi-Zone Information Troubleshooting
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
1.AVR988EU_101_4th.indd 16 2007/09/13 11:31:19
To Next Page
Loading...
