s
Tone Control
Adjust the tonal quality of the sound.
Tone Defeat
Turn tone adjustments off.
[Selectable items]
ON
: Playback without tone adjustment.
OFF
: Allow tone adjustment (treble, bass).
The tone cannot be adjusted when in the DIRECT mode.
Bass
Adjust low frequency range (bass).
[Variable range]
–6dB ~ +6dB
Treble
Adjust high frequency range (treble).
[Variable range]
–6dB ~ +6dB
“Bass” and “Treble” can be set when “Tone Defeat” is set to “OFF”.
0
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
f
RESTORER
This function restores compressed audio signals to how they
were before compression and corrects the sense of volume of
the bass and treble to obtain richer playback sound.
[Selectable items]
OFF
:
Do not use RESTORER.
Mode1
(RESTORER 64):
Optimized mode for compressed sources with very weak highs.
Mode2
(RESTORER 96):
Apply suitable bass and treble boost for all compressed sources.
Mode3
(RESTORER HQ):
Optimized mode for compressed sources with normal highs.
About the RESTORER function
• Such compressed audio formats as MP3, WMA (Windows Media
Audio) and MPEG-4 AAC reduce the amount of data by eliminating
signal components that are hard for the human ear to hear. The
RESTORER function generates the signals eliminated upon
compression, restoring the sound to conditions near those of the
original sound before compression. It also corrects the sense of
volume of the bass to obtain richer sound with compressed audio
signals.
• This is displayed on the menu and can be set when the input source
is selected to “XM”, or analog signals (including AM/FM signals) or
PCM signals (fs = 44.1/48 kHz) are input.
Operating from the main unit or remote control
unit
During playback, press the RESTORER button.
When set to something other than “OFF”, “ ” is displayed.
The default setting for “iPod” is “Mode3”. All others are set to “OFF”.
(RESTORER 64)
(RESTORER 96)
(RESTORER HQ)
d
Room EQ
Select room equalizer for current environment.
Operating from the main unit or main remote
control unit
Press the ROOM EQ button on the main unit or the EQ button on the
main remote control.
AudysseyOFF
Audyssey Byp. L/R
Audyssey Flat
Manual
When “Audyssey” is selected, “ ” lights.
When “Audyssey Byp. L/R” or “Audyssey Flat” is selected, or when
the auto setup measuring results have changed, “ ” lights.
• “Audyssey”, “Audyssey Byp. L/R” and “Audyssey Flat” can be
selected after the auto setup procedure has been performed.
• If the settings of the speakers for which “None” has been determined
at “Auto Setup” are changed, “Audyssey”, “Audyssey Byp. L/R” and
“Audyssey Flat” cannot be selected and measurements have to be
taken again to include the newly-added speakers.
• When using headphones, “Room EQ” is always set to “OFF”.
[Selectable items]
Audyssey
: Optimize frequency response of all speakers.
Audyssey Byp. L/R
: Optimize frequency response of speakers
except front L and R speakers.
Audyssey Flat
: Optimize frequency response of all speakers to
flat response.
Manual
: Apply frequency response set with “Manual
EQ” (vpage 29).
OFF
: Turn equalizer off.
1.AVR988EU_101_4th.indd 43 2007/09/13 11:32:31
To Next Page
Loading...
Need help?
General
