Denon AVR-991

102
ENGLISH
Surround
Surround mode (vpage43)
NOTE
Input signal types and formats
ANALOG
PCM DTS-HD DTS DOLBY DOLBY DIGITAL
LINEAR PCM
(multi ch)
LINEAR PCM
(2ch)
DTS-HD
Master
Audio
DTS-HD
High
Resolution
Audio
DTS
EXPRESS
DTS ES
DSCRT
(With Flag)
DTS ES
MTRX
(With Flag)
DTS
(5.1ch)
DTS 96/24
DOLBY
TrueHD
DOLBY
DIGITAL Plus
DOLBY
DIGITAL EX
(With Flag)
DOLBY
DIGITAL EX
(With no
Flag)
DOLBY
DIGITAL
(5.1/5/4ch)
DOLBY
DIGITAL
(4/3ch)
DOLBY
DIGITAL
(2ch)
DOLBY SURROUND
DOLBY PRO LOGIC g CINEMA A-DSX S S S
DOLBY PRO LOGIC g MUSIC A-DSX S S S
DOLBY PRO LOGIC g GAME A-DSX S S S
DOLBY PRO LOGIC A-DSX
S S S
Audyssey A-DSX
S S S S S S
MULTI CH IN
MULTI CH IN
z5 F
MULTI CH IN + PLgx CINEMA z2z3 S
MULTI CH IN + PLgx MUSIC z1z3 S
MULTI CH IN + PLgz z4 S
MULTI CH IN + Dolby EX
z3 S
MULTI CH IN 7.1
z3 F D (7.1)
Audyssey A-DSX
S
DIRECT
DIRECT
S S S S S S S S S S S S S S S S S
PURE DIRECT
PURE DIRECT
S S S S S S S S S S S S S S S S S
DSP SIMULATION
MULTI CH STEREO
S S S S S S S S S S S S
ROCK ARENA
S S S S S S S S S S S S
JAZZ CLUB
S S S S S S S S S S S S
MONO MOVIE
S S S S S S S S S S S S
VIDEO GAME
S S S S S S S S S S S S
MATRIX
S S S S S S S S S S S S
VIRTUAL
S S S S S S S S S S S S
STEREO
STEREO
F S F S S S S S S S S S S S S S S
z1 If “Speaker Config.” – “S.Back” (vpage78) is set to “None”, this surround mode cannot be selected.
z2 If “Speaker Config.” – “S.Back” (vpage78) is set to “1spkr” or “None”, this surround mode cannot be selected.
z3 This surround mode can be selected when “Amp Assign” (vpage77) is set to “Normal”.
z4 If “Speaker Config.” – “F.Height” (vpage78) is set to “None”, this surround mode cannot be selected.
z5 The same was when “Audyssey DSX™” (vpage75) setting is set to “ON”.