6
To store another button, repeat steps 4 and 5.
7
When you have finished storing the remote control
codes, press RC SETUP.
“OK” flashes four times on the remote control unit and the normal
operation mode is restored.
0
There are some remote control units that cannot be programmed, or even if they
can be programmed, they may not operate correctly. If this happens, use the
remote control unit supplied with the AV equipment to operate it.
0
The operations of the programmed buttons override the preset memory. If you do
not require the programmed buttons, erase the stored remote control codes to
return to the initial settings. (v p. 287)
0
The number of buttons that can be stored varies depending on the remote control
unit used. If you have stored the maximum number of buttons allowed for the
remote control unit, “FAIL” appears on its display.
NOTE
0
You cannot store the remote control code in the ZONE SELECT, RC SETUP,
POWER X, QUICK SELECT 1 – 4, ECO, SOUND MODE, SLEEP, MACRO A – D
and input source select button.
Contents Connections Playback Settings Tips Appendix
286
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
