Operating learning function
If the unit does not operate even when the preset code is registered, use
the learning function. Remote codes for different devices can be
remembered for use by the Denon remote control included with this unit.
o
Remembering remote control codes from
other devices
1
Press and hold RC SETUP for more than 3 seconds.
“SETUP” and p indicator flashes twice on the remote control unit.
2
Use ui to display “LEARN” on the remote control unit
and press ENTER.
3
When “DEVIC” appears on the remote control unit,
press the input source select button of the AV
equipment that you want to store.
0
You cannot store the remote control code in the AVR button.
0
Before using the learning function, register a preset code for a
mode other than AVR preset to each input source switch button.
(“Registering preset codes” (v p. 279))
4
When “KEY” appears on the remote control unit, press
the button that you want to store.
5
When “READY” appears on the remote control unit,
place the remote control unit of the AV equipment face
to face with main remote control unit (of this unit).
Next, press and hold down the desired button (that you
want to store) of the remote control unit of the AV
equipment.
.
0
When the button is correctly stored, “OK” flashes four times on
the remote control unit.
0
If the button is not correctly stored, “FAIL” flashes four times on
the remote control unit. If this happens, perform step 4 again.
Contents
Connections Playback Settings Tips Appendix
285
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
