Denon AVR-S510BT User Manual

o
Subwoofer
Turn subwoofer output on and off.
On
(Default):
The subwoofer is used.
Off: The subwoofer is not used.
0
This can be set when the surround mode is set to “Direct” or “Stereo”.
o
Set Defaults
The “Surr.Parameter” settings are returned to the default settings.
Restorer
Compressed audio formats such as MP3, WMA (Windows Media Audio)
and MPEG-4 AAC reduce the amount of data by eliminating signal
components that are hard for the human ear to hear. The “Restorer”
function generates the signals eliminated upon compression, restoring the
sound to conditions near those of the original sound before compression.
It also restores the original bass characteristics for a rich and expanded
tonal range.
On: Use “Restorer”.
Off
(Default):
Do no use “Restorer”.
0
This item can be set with analog signals or PCM signal (Sample Rate = 44.1/48
kHz) is input.
0
This cannot be set when the sound mode is set to “Direct”.
0
“Restorer” settings are stored for each input source.
0
The “Restorer” settings can be set even if RESTORER is pressed on the remote
control unit.
Contents Connections Playback Settings Tips Appendix
71
Front panel Display Rear panel Remote Index

Denon AVR-S510BT Specifications

General

Channels	5.2
Power Output	70 Watts per channel (8 ohms, 20 Hz - 20 kHz, 0.08% THD)
Frequency Response	10 Hz - 100 kHz
Response Bandwidth	10 Hz - 100 kHz
Total Harmonic Distortion	0.08%
Signal-To-Noise Ratio	98 dB
HDMI Inputs	5
HDMI Outputs	1
HDMI Pass-Through	Yes
HDMI Version	2.0
HDCP Version	2.2
Bluetooth	Yes
4K Ultra HD Pass-through	Yes
Audio Decoding	Dolby TrueHD, DTS-HD Master Audio
Wi-Fi	No
Inputs	5 HDMI, 2 digital optical, 2 analog
Outputs	1 HDMI
Dimensions	17.1 in x 12.6 in x 5.9 in
Amplifier Output Details	5 channels