No sound is produced from subwoofer.
0
Check the subwoofer connections. (v p. 24)
0
Turn on the subwoofer’s power.
0
Set “Speaker Layout” - “Subwoofer” on the menu to “Yes”. (v p. 94)
0
When “Crossovers” - “Front” in the menu is set to “Full Band”, depending on the input signal and the sound mode, no sound may be output from the
subwoofer. (v p. 96)
0
When no subwoofer audio signal (LFE) is included in the input signals, no sound may be output from the subwoofer. (v p. 97)
0
You can make the subwoofer always output sound by setting the “Subwoofer Output” to “LFE+Main”. (v p. 97)
DTS sound is not output.
0
Check that the digital audio output setting on the connected device is set to “DTS”.
0
Set “Decode Mode” on the menu to “Auto” or “DTS”. (v p. 88)
Dolby TrueHD, DTS-HD, Dolby Digital Plus audio is not output.
0
Make HDMI connections. (v p. 31)
0
Check the digital audio output setting on the connected device. On some devices, “PCM” is set by default.
Dolby PLg mode or DTS Neo:6 mode cannot be selected.
0
It cannot be selected when “No” is set for “Speaker Layout” - “Center” and “Surround”. (v p. 94)
0
Dolby PLg or DTS Neo:6 cannot be selected when using headphones.
“Restorer” cannot be selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS
surround, “Restorer” cannot be used. (v p. 77)
0
Switch to a sound mode other than “Direct” or “Pure Direct”. (v p. 60)
Contents
Connections Playback Settings Tips Appendix
113
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
