2. PANEL / REMOTE LOCK Selection Mode
2.1. Actions
Switch the PANEL LOCK and REMOTE LOCK modes between on and off.
2.2. Starting up
While holding down buttons "
TUNER PRESET CH+
" and "ZONE2 SOURCE" simultaneously, press the
power button to turn on the power.
Select the desired mode using the "
TUNER PRESET CH+
" button, then press the "
STATUS
" button to
conî™°rm.
2.3. Displaying and Selecting Each Mode
The information shown on the display switches each time the "
TUNER PRESET CH+
" button is
pressed.
Press the "
STATUS
" button to set the currently displayed mode and restart the device.
The setting with "
*
" is selected for each mode.
q
FP/VOL LOCK*ON
The buttons on the unit and the master volume knob does not function.
w
FP LOCK ON
The buttons on the unit does not function.
e
FP LOCK OFF
The PANEL LOCK mode is turned off.
r
RC LOCK ON
The device cannot be operated by the remote control.
t
RC LOCK *OFF
The REMOTE LOCK mode is turned off.
103
Caution in
servicing
Electrical Mechanical Repair Information Updating
To Next Page
Loading...
