EasyManuals Logo

Denon AVR-X3100W User Manual

Denon AVR-X3100W
297 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #181 background imageLoading...
Page #181 background image
o
About the main listening position
The main listening position is the position where listeners would
normally sit or where one would normally sit alone within the listening
environment. Before starting Audyssey
®
Setup, place the Sound
calibration microphone in the main listening position.
Audyssey MultEQ
®
XT uses the measurements from this position to
calculate speaker distance, level, polarity, and the optimum crossover
value for the subwoofer.
NOTE
0
Make the room as quiet as possible. Background noise can disrupt the room
measurements. Close windows and turn off the power on electronic devices
(radios, air conditioners, fluorescent lights, etc.). The measurements could be
affected by the sounds emitted by such devices.
0
During the measurement process, place cell phones outside the listening room.
Cell phone signals could disrupt the measurements.
0
Do not stand between the speakers and Sound calibration microphone or allow
obstacles in the path while the measurements are being made. Also, install the
Sound calibration microphone at least 20 inches (50 cm) away from the wall.
Failure to do so will result in inaccurate readings.
0
During the measurement process, audible test tones will come from the speakers
and subwoofer(s), but this is part of normal operation. If there is background noise
in the room, these test signals will increase in volume.
0
Operating VOLUME d f on the remote control unit or MASTER VOLUME on the
main unit during the measurements will cancel the measurements.
0
Measurement cannot be performed when headphones are connected. Unplug the
headphones before performing Audyssey
®
Setup.
Contents
Connections Playback Settings Tips Appendix
181
Front panel Display Rear panel Remote Index

Table of Contents

Other manuals for Denon AVR-X3100W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X3100W and is the answer not in the manual?

Denon AVR-X3100W Specifications

General IconGeneral
Receiver typeSurround
Speaker selectorA+B
Audio output channels7.1 channels
Total Harmonic Distortion (THD)0.08 %
Power output per channel (1KHz@6 Ohm)180 W
Power output per channel (20-20KHz@8 Ohm)105 W
HDMI in8
Remote control in1
Composite video in3
Multichannel audio input typeTerminals
Component video (YPbPr/YCbCr) in2
12V triggerYes
Speakers connectivity type-
Audio formats supportedAAC, AIFF, FLAC, MP3, WAV, WMA
Supported radio bandsFM
Product colorBlack
Audio decodersDolby Digital EX, Dolby Pro Logic IIx, Dolby Pro Logic IIz, Dolby TrueHD, DTS 96/24, DTS Neo:X, DTS-ES, DTS-HD Master Audio
Volume controlRotary
Apple docking compatibilityNot supported
Power consumption (standby)0.1 W
Power consumption (typical)600 W
Weight and Dimensions IconWeight and Dimensions
Depth388 mm
Width434 mm
Height167 mm
Weight10700 g

Related product manuals